Conditions for Settable Objects to Be Printed On

The conditions for objects to be printed on that can be set in the machine are shown below.

Maximum size Width 800 mm (31.5 in.)
Length 360 mm (14.2 in.)
Thickness Height 100 mm
Maximum weight 8 kg (17.6 lb.)
IMPORTANT:
  • Do not use objects to print on that are charged with static electricity.
  • This printer cannot print on all materials. When selecting the object to be printed on, be sure to carry out testing in advance to make sure that satisfactory print quality can be obtained.
  • There is a limit to the variation in the unevenness on the print surface.

    Notes When the Print Surface Is Uneven

  • Depending on the type of object to print on and the installation method, the height may not be set correctly. The machine may malfunction if printing is performed when an incorrect installation method is used or if printing is performed on an inappropriate material. Do not use objects to print on that match the status or material shown below.


 Objects that easily become loose If the object to be printed on is not firmly held in place, the head gap sensor cannot detect the height correctly. Be sure to secure the object to be printed on firmly in place. If you are not able to use the suction function to hold the object to be printed on in place and it becomes loose, you can use a substance such as commercially available adhesive tape to hold the object to be printed on in place.


Objects made from soft material If the object to be printed on is made from soft material, the pressure it applies on the head gap sensor is too weak. This prevents its height from being detected correctly.