You can use a positioning jig to fix the lower right corner of the flat table as the base position (home position) of the print area.
MEMO:
The positioning jig has a correct orientation for use. Use the figure above as a reference.
The side farther from the fixing holes comes to the outside.
Make sure that the top and bottom sides are correct.
You can also use multiple positioning jigs according to the size of the object to be printed on.
IMPORTANT:
When using positioning jigs, select objects to be printed on that have a thickness of 3 mm (0.1 in.) or more. If the object is less than 3 mm (0.1 in.) thick, the print surface will be lower than the positioning jigs, preventing height from being set correctly.
