Step 3: Securing the Print-head Carriage in Place Using the Retainer

Use the retainer that was stored during the installation of the machine.
  1. Open the panel cover.
    Remove the screw on the top of the panel cover, and then pull out the panel cover in the direction indicated by the arrow.


  2. Gently move the print-head carriage to the position in the following figure by hand.


    CAUTION:

    When moving the print-head carriage by hand, be sure to hold the specified positions.

    Moving it by holding positions other than those specified may deform and damage the cover.



    : Positions to hold with your hands

  3. Secure the print-head carriage in place using retainer C ().


  4. Push the print-head carriage to the right side.
    Push the print-head carriage until an audible click is heard.
    CAUTION:

    When moving the print-head carriage by hand, be sure to push the specified positions.

    Moving it by pushing positions other than those specified may deform and damage the cover.



    : Positions to push with your hands

  5. Close the panel cover.

    Catch the panel cover pins on the notches, and then attach the panel cover.



  6. Close the front cover.
    The machine is now ready to be moved.