Adjusting the AAS Offset

If a shift has been found as a result of an AAS offset test, adjust the deviations in the width and length.

Procedure
  1. Measure how much the cutting line () shifted using the printed lines () as a reference.
    Figure 1. AAS offset test result
    • Line parallel to the material-feed direction (): X
    • Line perpendicular to the material-feed direction (): Y

    AASoffset_adjust

  2. Press [MISC].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  3. Press [▶] several times to display the screen shown below.

    MENU_MISC_AAS-offset

  4. Press [ENTER].
  5. Press [▶] to move the cursor to X or Y, and then enter the offset value using [▲] or [▼].

    MENU_AAS-offset_value

    If the result is shifted to the positive direction, enter a negative offset. If the result is shifted to the negative direction, enter a positive offset. In the case of (A) in the sample AAS offset test result above, -1.00 is entered as the value for both X and Y.
  6. Press [ENTER].
  7. Press [ON/OFF LINE] to go back to the original screen.
  8. Run an AAS offset test again.