Cutting Machine Main Unit

Front

No.	Name	Function overview
	Pinch rollers	When you lower the lever, this part pinches the material. Lift the lever to release the material.
	Cutting carriage	Install the blade holder. This part moves to the left and right to cut the material.
	Grit rollers	These rollers feed the material to the front and rear.
	Grit patterns	These indicate the locations of the grit rollers. When loading the material, be sure to place the pinch rollers within the area indicated by each of these patterns.
	Blade protector	This is the path that the blade takes during cutting. It protects the tip of the blade.
	Operation panel	The panel containing the buttons used to operate the machine.
	Platen	This is the path over which the material passes.
	Cutting groove	The safe blade slides along the groove and separates the material.
	Rulers	Load the material using the rulers as a guide.
	Paper sensors	These sensors detect the presence/absence of material.

Rear

No.	Name	Function overview
	Small article storage	This space is for placing small tools such as clips and blades.
	Lever	Use this to raise and lower the pinch rollers. You operate this to move the pinch rollers or to load materials.

Side

No.	Name	Function overview
	Power-cord connector	This is for connecting a power cord.
	Power switch	Switch the power on/off.
	Ethernet connector	Use this to connect an Ethernet cable.
	USB connector	This is for connecting a USB cable.
	Serial connector (RS-232C)	Use this to connect the RS-232C cable. This is disabled when a USB cable is connected.