Replacing the Filter

This section explains how to replace the filter used for the mist fan that adjusts scattering of ink mist.

When the screen displays a message like the one shown, it means the item needs to be replaced. Replace with new items.



CAUTION:

Be sure to perform operations as specified by the instructions, and never touch any area not specified in the instructions.

Otherwise sudden movement of the machine may cause injury.

IMPORTANT:

  • A warning beep sounds 10 minutes after operation starts. Stop work and close the front cover. Press ENTER to exit the wiper replacement menu. After that, restart the procedure from the beginning.

  • Be sure to hold the handle of the front cover and open and close it gently.

  1. Press ENTER when the following screen appears.


  2. Remove the object to be printed on.
  3. Press MENU.
  4. Press ▼ several times to display the screen shown below.


  5. Press ▶ once, and then press ▼ several times to display the screen shown below.


  6. Press ▶ once, and then press ▼ several times to display the screen shown below.


  7. Press MENU.
    After "NOW PROCESSING.." is displayed and the operation for filter replacement is performed, the screen shown below appears.


    MEMO: Refresh the heads if the following message is displayed.


  8. Open the front cover.
    The screen shown below appears.


  9. Open the maintenance cover.
    Remove the screw on the top of the maintenance cover, tilt the maintenance cover forward slightly, and then pull out the maintenance cover in the direction indicated by the arrow.


  10. Touch the location shown in the figure to discharge any static electricity.


  11. Loosen the screw (1) and pull out the filter holder (3) of the carriage mist fan.
  12. Replace the filter (2).
    During the replacement, wipe away any buildup of ink around the outlet with a cloth.


  13. Tighten the screw while pushing the filter holder of the carriage mist fan.
    Insert the filter holder completely so that there is no gap in the insertion port.


  14. Press ENTER.
  15. When the following screen is displayed, close the front cover.


  16. Press ENTER.
    Start cleaning.
    When the following screen is displayed again, the filter replacement is finished.