Setting the Start Timer

You can set a timer so that the machine finishes starting by the set time.
Point:

  • Before configuring this setting, you need to set the date and time. For information about how to configure the settings, refer to "RELATED LINKS" at the end of this section.

  • The timer specifies the next start date and time. Setting a regular start time is not possible.

  • The timer can be set to a time between 10 minutes from the set date and time, to 23:50 3 days after the set date and time.

    • The minutes setting of the timer can be set at 10-minute intervals beginning with 00 minutes. Because setting less than 10 minutes is not possible, the following is an example of the shortest possible timer setting.

      Example Set date and time 12/03/17:33
      Configurable timer setting 12/03/17:50 to 12/06/23:50
  1. Press FUNCTION.
  2. Press ▼ several times to display the screen shown below.


  3. Press ▶ twice to display the screen shown below.


    MEMO:
    Refresh the heads if the following screen is displayed during operation. Afterward, start over from the beginning. Continuing with operation without refreshing the heads is possible, but print quality may be affected, and deterioration of the print heads may be accelerated, and is not recommended.


  4. Set the date and time at which the machine will finish starting.
    1. Press ▲ or ▼ to set the day.
    2. Press ▶.
    3. Press ▲ or ▼ to set the hour.
    4. Press ▶.
    5. Press ▲ or ▼ to set the minute.
    The number with the cursor (underline) is the one being set. You can use ◀ and ▶ to switch between the day, hour, and minute.
    MEMO:

    The start timer includes settings for day, hour, and minute. If the setting is configured at the end of the month, the setting will include up to 3 days into the following month.

  5. Press ENTER to confirm your entry.
  6. When the following screen is displayed, press ▲ or ▼ to set an action to be performed before startup completes.
    Startup will complete before the time set with the timer after the action configured here is performed.


    ACTION Explanation
    NONE No action is performed before startup.
    CIRCULATE The white ink is circulated to eliminate ink precipitation, which restores the ink concentration.
    CLEANING Normal cleaning is performed.
    CIRCULATE＋CL After circulating the white ink to eliminate ink precipitation, thereby restoring the ink concentration, normal cleaning is performed.
    MEMO:

    When performing "CIRCULATE," the required time will vary depending on the machine status. This may result in errors occurring for several minutes before startup finishes.

  7. Press ENTER to confirm your entry.
    The sub power switches off automatically.
    The key buttons on the operation panel flash slowly in order until the next time the machine starts.
    IMPORTANT:

    After the sub power switches off, if the operation panel key buttons remain unlit, the timer was not configured. Perform the procedure again.

    MEMO:

    If the following messages are displayed before the sub power is turned off, perform the operations indicated by the messages.

    Messages Explanation






    		Close the applicable cover as directed in the message. The sub power turns off automatically when the cover is closed.


    		Remove the white ink cartridge, shake it 50 times (about 20 seconds) with a stroke length of around 5 cm (2 in.) from each end, and then reinsert it. Afterwards, press [ENTER] to switch off the sub power.
    MEMO:

    • If you switch on the sub power button before the set start time, the start timer is cleared. To enable the start timer, set it again.

    • If the front cover is open or an ink cartridge is not inserted appropriately when the set start time is reached, an error will occur and the machine will not be able to start.