Adjusting the Printing Area

Set the margins.

This sets the distance from the left or right media clamp to the corresponding left or right edge of the printing area.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the screen shown below.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶] to display the screen shown below.


  5. Press [▲] or [▼] to select the margin from those shown below.
    • "5 mm"
    • "10 mm"
    • "25 mm"
  6. Press [ENTER] to confirm your entry.

    • If the media has already been set, the message "PRESS ENTER KEY TO SET UP" is displayed on the screen.

    • If the media has not yet been set, press [MENU] to go back to the original screen.
    MEMO:

    Default setting: "10 mm"