Setting the Cutting Speed

If the design peels off or if the cut lines are not clean, reduce the cutting speed. When the cutting speed is too fast, extra load is applied to the material, which can move the material up and down during cutting. Also reduce the cutting speed in such cases. The cutting speed and quality mutually affect each other. Therefore, use a cutting speed within the range that can maintain cutting quality while selecting cutting quality that matches the cutting speed.

Procedure
  1. Press [SPEED].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.

    The current cutting speed is displayed.


    MENU_Speed

  2. Press [▲] or [▼] to change the cutting speed.
  3. Press [ENTER] to confirm your entry.

    The current cutting quality is displayed.


    MENU_Speed_Quality

  4. Press [▲] or [▼] to set the quality.
    Quality improves in this order: "Draft", "Fair", "Normal", "Fine", and "Small Letter". Normally, quality is set to "Normal". If you need to cleanly cut small text or complex graphics, select "Small Letter".
  5. Press [ENTER] to confirm your entry.
  6. Press [ON/OFF LINE] to go back to the original screen.
    MEMO
    • [SPEED]
      • Default setting: 72 cm/s (28.34 in./s)
      • Setting range: 3 to 153 cm/s (1.18 to 60.23 in./s) (changeable in 3 cm/s [1.18 in./s] increments)
    • Quality: "Normal"