Turning Off Rear Paper Sensor Detection

You can turn off the detection of the paper sensor at the rear side of the cutting machine. As this feature informs the machine that the material is properly loaded, we recommend that you set this to "Enabled" for normal use. This option is effective for measuring the material size in roll mode or edge mode.
Procedure
  1. Press [MISC].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] several times to display the screen shown below.

    MENU_MISC_RearSensor

  3. Press [ENTER].
    The current setting is displayed.
  4. Press [▲] or [▼] to set this to "Disabled".
  5. Press [ON/OFF LINE] to go back to the original screen.
    MEMO Default setting: "Enabled"