Prioritizing the Cutting Settings of This Machine

The cutting settings on the operation panel can be prioritized over the printer driver settings. For cutting settings (blade force, speed, quality, and offset), the printer driver (or GreatCut-R/VersaWorks) settings are usually prioritized.
Procedure
  1. Press [TOOL SELECT].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] several times to display the screen shown below.

    MENU_TOOL_SetCmd
  3. Press [ENTER].
  4. Press [▲] or [▼] to select "Control panel only".
    This setting prioritizes the cutting conditions set up on the operation panel over the printer driver settings. If this is set to "Accept setup command", the printer driver (or GreatCut-R/VersaWorks) settings are prioritized.
    MENU_CMD_PanelEnable
  5. Press [ENTER] to confirm your entry.
  6. Press [ON/OFF LINE] to go back to the original screen.
    MEMO Default setting: "Accept setup command"