Setting Up Perforated Cutting from the Operation Panel

You can set up perforated cutting on the operation panel.
Procedure
  1. Press [MISC].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] several times to display the screen shown below.
    The current setting is displayed.
    MENU_MISC_DieKissC

  3. If "Die/Kiss Cut" is "OFF", press [▲] or [▼] to switch "Die/Kiss Cut" to "ON".
  4. Press [ENTER].
  5. Set the cutting lengths for "Die Cut" and "Kiss Cut".

    MENU_DieKissC_Length

    1. Press [◀] to select "Die Cut". Press [▶] to select "Kiss Cut".
    2. Press [▲] or [▼] to change the value.
  6. Press [ENTER].
  7. Set the blade forces for "Die Cut" and "Kiss Cut" on the following screen.

    MENU_DieKissC_Force

    1. Press [◀] to select "Die Cut". Press [▶] to select "Kiss Cut".
    2. Press [▲] or [▼] to change the value.
  8. Press [ENTER].
  9. Press [ON/OFF LINE] to go back to the original screen.
    MEMO Default setting: "OFF"

    Cutting length setting range (Die Cut/Kiss Cut): 0.1 to 100 mm/0.1 to 100 mm (changeable in 0.1 mm increments)

    Blade force setting range (Die Cut/Kiss Cut): 5 to 600 gf/5 to 600 gf (changeable in 5 gf increments)