Setting Up Perforated Cutting Using the Printer Driver

Save the cutting lines in the cutting data as perforated cutting lines and set up perforated cutting using the printer driver.
Procedure
  1. Start Adobe Illustrator or CorelDRAW.
  2. Click File - Open to open the file.
  3. Set the cutting line to be perforated to green (R: 0 G: 255 B: 0) with a width of 0.001 mm (0.04 mil).
  4. Open the Printing Preferences window.

    Sending Adobe Illustrator Cutting Jobs from the Printer Driver

    Sending CorelDRAW Cutting Jobs from the Printer Driver

  5. Select the Cutter tab, and then select the Die Cut check box.

    The blade forces and cutting lengths for Die Cut and Kiss Cut set with the driver are applied.

    If the Die Cut check box is cleared, the "Die/Kiss Cut" cutting conditions set with the operation panel are applied.


    Driver_PerforationSetting

  6. Set the cutting lengths and blade forces for Die Cut and Kiss Cut, respectively.
    The ranges of Die Cut length and Kiss Cut length are 0 to 2000 mm (0 to 78.74 in.) and 0 to 100 mm (0 to 3.93 in.), respectively.
    Die Cut length > Kiss Cut length Die Cut length = Kiss Cut length Die Cut length < Kiss Cut length

    Perforation_DiecC_larger
    Perforation_equal
    Perforation_kissC_larger
  7. Click OK.