Cutting the Corners Longer to Make It Easy to Detach Cutting Data (Over Cut)

Cutting the top left corner of the cutting line slightly longer makes it easy to peel off the sticker. If the over cut function is enabled when cutting small characters or complex shapes, areas of the material that are required may be cut. Therefore, this function is turned off for normal use.


OverCut

Procedure
  1. Press [TOOL SELECT].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] to display the screen shown below.
    The current value is displayed on the screen.

    MENU_TOOL_OverC_1

  3. Press [▲] or [▼] to enter the over cut length.
  4. Press [ENTER] to confirm your entry.
  5. Press [ON/OFF LINE] to go back to the original screen.
    MEMO
    • Default setting: 0.00 mm
    • Setting range: 0.00 to 3.00 mm (0.00 to 0.12 in.) (changeable in 0.05 mm [0.01 in.] increments)