Setting the Output-start Location (Printing and Cutting)

Set the cutting start position (origin). When printing and cutting, the crop marks are read by the AAS sensor equipped on the cutting carriage, and therefore the cutting carriage must be placed near the first crop mark.

MEMO If the cutting carriage is placed away from the first crop mark, crop marks cannot be detected.
Procedure
  1. Check that the material has been properly loaded and set up.
  2. Press [◀], [▼], [▲] or [▶] to move the center of the blade to the crop mark origin point.
    MEMO The origin point can be set in either online mode or offline mode.
  3. Press [ENTER].
    The origin point (cutting start location) is set.