Automatic Detection of Material Feed Direction
Normally you load the material with the crop mark origin at the front right of the cutting machine. If crop marks are set up using the AAS plug-in, the material feed direction is recognized as correct even when the material is loaded in reverse direction, and the material is cut according to the contour line of the print.
MEMO The cutting order is detected by a sensor according to the shape of each crop mark created at the four corners. Automatic detection of material feed direction only supports 180-degree orientations.
Normally, the machine reads the crop marks in the order of 1 (crop mark origin), 2, 3, and finally 4.
Crop marks on material loaded in reverse direction (rotated) will be read in the order of 3, 4, 1 (crop mark origin), and 2. The feed direction is detected when the fourth crop mark is read, and the information is sent to the driver.
