Drying the Trailing Edge of the Printing Area on the Dryer (When Printing and Cutting)

To dry the ink thoroughly, configure the settings so that the media is fed until the trailing edge of the printed area is put on the dryer after the printing is finished. This setting applies to output data designed for printing and cutting.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the screen shown below.


  3. Press [▶] twice, and then press [▼] once to display the screen shown below.


  4. Press [▶] to display the screen shown below.


  5. Press [▲] or [▼] to select "ENABLE" or "DISABLE".
    "ENABLE" Media feed is performed until the trailing edge of the printing area is positioned on the dryer. The margin between the print-end position and the next print-start position is set to a value of 100 mm (3.9 in.) when [OPTION DRYER] is set to "DISABLE" and 280 mm (11.0 in.) when it is set to "ENABLE".
    "DISABLE" Media feed stops when printing ends. This means that the trailing edge of the printing area is not fed to the dryer unless you continue with a subsequent printing operation.
  6. Press [ENTER] to confirm your entry.
  7. Press [MENU] to go back to the original screen.
    MEMO:
    • Default setting: "DISABLE"