This setting is useful when you want to switch off the media heating system collectively, such as when performing only cutting. Setting "POWER" to "OFF" in the heater settings will make it impossible to set the temperature of the print heater and dryer.
Procedure
Press [FUNCTION].
Press [▼] several times to display the screen shown below.
Press [▶] to display the screen shown below.
Press [▶].
Press [▲] or [▼] to select "OFF".
Press [ENTER] to confirm your entry.
The settings for the print heater and dryer are turned off.
Press [FUNCTION] to go back to the original screen.
MEMO:
Default setting: "ON"
IMPORTANT:
When this is set to "OFF", the heater will not turn on even if the heater temperature is set in the included software RIP.
