Setting the AAS Detection Mode

Normally the crop mark origin is set at the front right, facing the machine, but when crop marks are set up using the AAS plug-in, you can specify the reading direction of the crop marks for the loaded material.
Procedure
  1. Press [MISC].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] to display the screen shown below.

    MENU_MISC_AAS-detect

  3. Press [ENTER].
    The current setting is displayed.
  4. Press [▲] or [▼] to set the material detection mode.

    MENU_detect_auto

    		 Detect upon rotating (by 180 degrees) according to the orientation of the crop marks printed on the material

    MENU_detect_reverse

    		 Detect from reverse direction (rear)

    MENU_detect_forward

    		 Detect from front
  5. Press [ENTER].
  6. Press [ON/OFF LINE] to go back to the original screen.
    MEMO Default setting: Auto detection