What to Do First after Installation

Accurately Adjusting the Misalignment of the Ink Landing Position

This adjusts the misalignment of the ink landing position.

This adjustment must be performed in the following cases.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the screen shown below.


  3. Press [▶], then [▲] to display the screen shown below.


  4. Press [▶] to display the screen shown below.


  5. Press [ENTER].
    Printing of the test pattern starts.
  6. When printing is finished, press [▼], then [▶] to display the screen shown below.


  7. View the printed test pattern, and then determine the correction values from "MEDIA GAP ADJ. NO.1 H1" to "MEDIA GAP ADJ. NO.1 H4."
    Select the value that gives the least misalignment between the two lines. In the case of the following figure, select "+5" for H1 and H3 and "+4" for H2 and H4. When you cannot choose between two sequential numbers, select a value that is between them (you can set correction values in units of "0.5").


  8. Set the correction values from "H1" to "H4."
    1. Press [◀] or [▶] to select a value from H1 to H4.
    2. Press [▲] or [▼] to select the correction value.


    3. When you have finished setting the correction values, press [ENTER].
      The screen shown below appears again.


  9. Press [▼] to display the screen shown below.


  10. Set the correction values from "MEDIA GAP ADJ. NO.2 H1" to "MEDIA GAP ADJ. NO.2 H4" in the same manner as step 8.
  11. Press [▼] to display the screen shown below.


  12. Press [ENTER].
    Printing of the test pattern starts.
  13. Check the test pattern to see whether the correction was successful.
    For all the correction values, check that the misalignment is minimized for the two vertical lines indicated by "" (that is, the current correction value). If the misalignment is smaller for another set of vertical lines, set the correction value again.
  14. When you have successfully performed the correction, press [MENU] to go back to the original screen.