1. Install the media on the media holders.

The media holders of this machine are designed to be used exclusively with media that has a paper tube (core) with an inner diameter of 3 inches. To use 2-inch media, the optional media flanges are required. For information about optional items, contact your authorized Roland DG Corporation dealer or visit our website (http://www.rolanddg.com/).
Procedure
  1. Open the front cover.
  2. Move the media clamps to the outside of the grit rollers on the left and right edges respectively.


  3. Loosen the retaining screws of the media holders, and then draw them to the left and right ends respectively.


  4. Place the media on the media stays.


    Point:
    Place the media stays at positions that are 1/4 the length of the media from each end of the media.


    IMPORTANT:

    Do not leave media on the media stays for a long period of time. Doing so may lead to the media becoming deformed. Exercise caution.

  5. Fit the paper tube (core) of the media onto the end cap of the left media holder.


  6. Move the right media holder to fit its end cap onto the paper tube (core) of the media.
    Fit the paper tube onto the media holders securely to prevent the media from moving easily.


    IMPORTANT:

    Position the left media holder correctly.

    If the position of the left media holder is incorrect, media may not be fed properly, which will have an adverse effect on the printing results. Use the following procedure to determine the appropriate position.

    Do not secure the media holders in place just yet.

    In the following procedure, you will adjust the positions of the media holders before securing them in place. Do not secure them in place just yet.

    IMPORTANT:

    Do not touch the media holder adjuster.

    The media holder adjuster is an important part that adjusts the position of the media. When this machine is installed, a suitably qualified worker performs an optimal adjustment that matches the installation environment. Changing the adjusted position of the media holder adjuster may lead to the media feeding at an angle or other adverse effects.

    If you change the media holder adjuster position by mistake, contact your authorized Roland DG Corporation dealer.



    ①: Media holder adjuster